Cast aluminum, bronze, & cast iron flywheels.
ALUMINUM 1-1/2 oz.
BRONZE 5 oz.
ALUMINUM 2-1/2 oz.
Save some time building your Red Wing Engine Kit. This pack includes all of the Special Model Size Hex Head Bolts, Nuts and Studs required to complete your Red Wing Engine. Available for either the Air Cooled or the Water Cooled engine.
Fuel Line Fitting Kit for use on Water Cooled or Air Cooled Red Wing Gas Engines. Get your engine running a little sooner with a kit of finished fuel line parts ready to install.
This kit includes the following:
1 - 5/16 Globe Angle Valve
1 - 5/16...
These piston rings are for a 1.250" cylinder diameter and 3/32" wide groove. Two included per package.
This wire provides an authentic look to any gas model engine project.
Spark Plug Wire -14 GA cloth covered wire. Orange (Oak) with Red & Black Tracers. For the Red Wing or other model engines.
Primary Wire - 16 GA cloth covered wire. Choose from...
Metric 10X1mm Tap for threading the spark plug hole on your engine. Use a letter "T" tap drill.
The NGK CM-6 is considered standard for the Red Wing as well as other model engines.
1/3 SCALE AIR COOLED GAS ENGINE
The 2.5 HP air cooled Red Wing Motor was the inspiration for this one third scale model. Our 'Unmachined Casting Kit' comes with 9 bronze castings and 11 iron castings and small parts such as springs, timing gears, piston...
1/4 SCALE WATER COOLED GAS ENGINE
The 5 HP Red Wing Motor was the inspiration for this fully functional quarter scale model. It runs on regular gasoline and uses a buzz coil as an ignition source.
For the machinist we also offer our 'Unmachined Casting...
This high quality Buzz Coil provides a powerful spark. It will operate from a wide range of DC voltages. A small 9 Volt rechargeable battery pack is commonly used as a power source. It works just as well when a 12 Volt car battery is used as the power...
This bar stock package is available for those not lucky enough to have common materials laying around the shop. Materials like flat, round, and hex stock for the Red Wing engine, plastic and copper rod for the ignition parts, hex and round steel bar for...
LUNKENHEIMER 1/8" SCALE MIXER
Lunkenheimer style fuel mixer for model gas engines threaded with a 1/8" NPT intake. This is the fuel mixer used on our Red Wing model gas engines, both the 1/4 scale Water Cooled and the 1/3 scale Air Cooled Engine...